Bearing maintenance and bearing cleaning
How to clean bearings?
Step 1:Clean the bearings and remove rust-proof oil.
Using refined kerosene and naphthol.After soaking in a highly volatile solvent and cleaning it by hand, Use gasoline, ethanol, etc. to remove refined kerosene, etc. When using an air gun to blow off the cleaning oil, attention should be paid to the cleanliness of the air. When using oil and gas lubrication, it can be directly used. But it is recommended to apply or soak in lubricating oil or low-viscosity oil after cleaning before use.
Step 2: Dry the bearings to ensure there is no residual moisture.
When using grease lubrication, in order to prevent the grease from flowing out. The bearings need to be thoroughly dried. Additionally, Lubricating grease should be immediately sealed after drying. Can be dried with warm air (pay attention to the air Cleanliness). It can also be dried in a constant temperature bath.
Step 3: Seal the lubricating grease.
After packaging, rotate the rolling part by hand to fully apply lubricating grease. When applying lubricating grease to the outer diameter surface (inner diameter surface) of the roller bearing, rotate the roller with your fingertips to allow the lubricating grease to seep into the inner ring (outer ring).
